Aiper Scuba S3 Cordless Robotic Pool Cleaner w/ WavePath 3.0 Navigation, Dual-Stage Filtration, JetAssist Waterline Cleaning & App Control. Floor, Walls, Waterline Pre-order 31/8/2026

For pools with a larger amount of visible debris such as leaves and stones, use the 180 μm filter basket on its own. When larger debris is minimal and you want to target finer particles such as silt, fine dust or some algae, install the 3 μm MicroMesh Ultra-Fine Filter together with the filter basket.

Pro Tip: Empty and rinse the filter basket after each cleaning cycle. When using the MicroMesh Ultra-Fine Filter, remove it and rinse it separately on both the inside and outside. For a deeper clean, use a Robotic Filter Cleaner Spray to help break down oils and fine residue.

Scheduled Cleaning is set through the Aiper App and is designed for routine floor cleaning. Three preset schedules are available: 45 minutes × 4 cycles, 60 minutes × 3 cycles, or 90 minutes × 2 cycles. Fully charge the cleaner before starting a scheduled cleaning program.

Remove the cleaner from the pool after each cleaning cycle rather than leaving it submerged for extended periods. Empty and rinse the filter basket and MicroMesh filter after use, allow the cleaner to drain, and store it in a well-ventilated area away from direct sunlight.

The Scuba S3 is designed to operate in water temperatures from 10–40°C, with pH between 7.0 and 7.8, chlorine up to 4 ppm and salt concentration up to 5,000 ppm. The operating water depth is 0.5–3 m.

Turn the pool pump off while the Scuba S3 is cleaning to help prevent the cleaner from becoming caught around the main drain. Do not operate the cleaner while people or animals are in the pool.

Fully charge the cleaner before long-term storage, then switch it off and disconnect the charger. Clean and dry the cleaner and charging port, close the charging-port cover, and store the unit indoors in a cool, dry and well-ventilated location. Recharge the battery every six months during extended storage.